Pulnix TMC-6700 Series Uživatelský manuál stáhnout pdf (Strana 58)

Kamerakabel

_______________________________________________________________________________________________________

INSPECTA hardware manual Rev 1.86 page 58

The cable is split on the camera side. The 37-pin Sub-D connector

carries data, whereas the 15-pin male Sub-D connector carries

the EXSYNC signal.

camera mode bpp

0x5B8 8, dual output

6.14 Dalsa Spyder SP-14

(Part # KKRDDALS**)

for DALSA SPYDER SP-14

Inspecta camera mode

Inspecta-4D 0x49A

Camera set to:

EXSYNC = Level Mode

GAIN = 4

SPEED = 40Mhz

6.15 Power Cable for Dalsa Spyder SP-14

(Part # KKRPDALS**)

use this cable to supply Dalsa Spyder SP-14 by the PC.

6.16 Power Cable for Hitachi KPF-1xx

(Part # KKRPKPF**)

use this power cable for Hitachi KPF-1xx.

6.17 Digital Cameras Power Cable

(Part # KKRPDIG**)

use this power cable for all Digital cameras with 12-pin Hirose connector,

except Hitachi KPF-1xx (KKRPKPF**)

6.18 Hitachi HV-D30 3-chip analog

(Part # KKRH**HVD30)

Camera modes for Hitachi HV-D30:

camera

mode

bits per pixel HV-D30 settings, menu buttons

0x578 32bpp,

Inspecta-3/4A

Special menu: UP+MENU SW on (1 sec)->

OUTPUT/SYNC -

SYNC ON G: on

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 122 123

Žádné komentáře

Pulnix TMC-6700 Series Uživatelský manuál Strana 58